CWE-1191: On-Chip Debug and Test Interface With Improper Access Control

How it's found

On-Chip Debug and Test Interface With Improper Access Control is typically found by tracing untrusted input from where it enters the system to the point where it is used without the check or neutralization this weakness describes, combining manual code review with dynamic testing.

A device's internal information may be accessed through a scan chain of interconnected internal registers, usually through a JTAG interface. The JTAG interface provides access to these registers in a serial fashion in the form of a scan chain for the purposes of debugging programs running on a device. Since almost all information contained within a device may be accessed over this interface, device manufacturers typically insert some form of authentication and authorization to prevent unintended use of this sensitive information. This mechanism is implemented in addition to on-chip protections that are already present. If authorization, authentication, or some other form of access control is not implemented or not implemented correctly, a user may be able to bypass on-chip protection mechanisms through the debug interface. Sometimes, designers choose not to expose the debug pins on the motherboard. Instead, they choose to hide these pins in the intermediate layers of the board. This is primarily done to work around the lack of debug authorization inside the chip. In such a scenario (without debug authorization), when the debug interface is exposed, chip internals are accessible to an attacker.

Vulnerable vs. safe

If the JTAG interface on this device is not hidden by the manufacturer, the interface may be identified using tools such as JTAGulator. If it is hidden but not disabled, it can be exposed by physically wiring to the board.

By issuing a "halt" command before the OS starts, the unauthorized user pauses the watchdog timer and prevents the router from restarting (once the watchdog timer would have expired). Having paused the router, an unauthorized user is able to execute code and inspect and modify data in the device, even extracting all of the router's firmware. This allows the user to examine the router and potentially exploit it.

In order to prevent exposing the debugging interface, manufacturers might try to obfuscate the JTAG interface or blow device internal fuses to disable the JTAG interface. Adding authentication and authorization to this interface makes use by unauthorized individuals much more difficult.

Consequences

• Read Application Data
• Read Memory
• Execute Unauthorized Code or Commands
• Modify Memory
• Modify Application Data
• Bypass Protection Mechanism

Mitigations

• Architecture and Design: If feasible, the manufacturer should disable the JTAG interface or implement authentication and authorization for the JTAG interface. If authentication logic is added, it should be resistant to timing attacks. Security-sensitive data stored in registers, such as keys, etc. should be cleared when entering debug mode.

Where this fits in a TurboPentest engagement

This weakness is not covered by the automated black-box pentest. IntegSec pentesters cover it in a manual engagement.

Frequently asked questions

Related CWEs

• Pillar weakness
  CWE-284: Improper Access Control